Zeph Gage has built a rear-only portal axle for an XJ Jeep using a mix of production and military-derived components plus custom fabrication. The setup is designed to deliver the clearance benefits of portal axles at roughly one-fifth the cost of a typical $20,000 set, while avoiding the packaging work required to convert both ends of a vehicle.
Portal axles place a set of gears behind each driven wheel rather than letting axle shafts and other components hang below the transmission and transfer case. That lets the axle tubes sit higher and leaves less hardware below the frame. Tall tires can then add further ground clearance. The trade-off is cost and complexity, which is why complete portal-axle kits from specialists such as 74Weld are so expensive.
A flipped differential and military-derived hubs
Gage’s rear axle combines a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals such as the Humvee units reverse the rotation of the input shaft. To make the Ford 9-inch work with that reversal, Gage flipped the differential upside down so the driveline turns in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, creating what amounts to a budget high-pinion unit from low-pinion parts turned on their head.
The conversion is said to add about six inches of clearance. It also retains full shock travel, a difficult goal with portal axles, and reduces stress on the differential itself. The reduced stress is intended to make the setup effectively bulletproof.
Why only the rear axle?
Installing a portal axle at the rear without matching it up front is a common trick in the remote-control rock-crawler scene. By keeping the front solid axle, Gage avoided the packaging constraints that arise when adding portal axles to a vehicle that never had them from the factory. He also did not have to limit shock travel to make the front fit, and the ride height did not rise to an extreme level. The result is meant to combine extra rear clearance with a simpler front end: the rear is less likely to hang up on obstacles that the front can steer around.
Custom brackets and Ford Fusion brakes
The axle is not an off-the-shelf solution. Gage fabricated homemade brackets and custom-tapped plates, and he built a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it has an integrated electric emergency-brake solenoid, and partly because it helps with clearance.
The finished XJ can drive over a five-gallon bucket and still have several inches of spare clearance. That means the rear end is less likely to get hung up on obstacles that the front end can steer around. The build required considerable thought and custom work to get right, but it shows how a reversed differential and surplus military hubs can produce a capable rear portal axle at a fraction of the usual price.
