Researchers in China have identified progressive wear of screen-mesh knuckles as a main cause of efficiency loss in copper-plated silicon heterojunction (HJT) solar cells during photoresist screen printing, and have proposed an emulsion buffer layer to reduce the damage.
Screen printing is widely used to metallize solar cells, but mechanical pressure and thermal treatment can degrade device performance. The issue is especially relevant to copper-plated HJT cells, which are being pursued as a way to lower metallization costs and reduce reliance on silver. In these cells, screen printing can damage sensitive passivating contact structures, raising recombination losses and lowering conversion efficiency.
A different contact problem
Lang Zhou, the corresponding author, said the photoresist printing step in HJT cells differs fundamentally from conventional silver-paste printing. In silver-paste screens, openings account for only 2–5% of the total area, while an emulsion layer covers the rest and prevents direct contact between the mesh and the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage so that resist is deposited uniformly across the wafer. As a result, the mesh comes into direct and extensive contact with the wafer during every printing cycle, Zhou said.
Efficiency and lifetime losses
Previous investigations cited by the researchers found that conversion efficiency declined from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses were attributed mainly to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses, suggesting damage to the amorphous silicon/crystalline silicon interface.
Emulsion buffer and trade-off
To address the problem, the researchers developed an emulsion buffer layer intended to prevent direct contact between the screen mesh and the wafer. They evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. The results showed a trade-off: higher emulsion coverage reduced mechanical damage but impaired photoresist coating uniformity and ink distribution.
An emulsion coverage ratio of 4.7% provided the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The researchers attributed the improvement to the emulsion layer preventing direct contact between the mesh and the wafer, thereby reducing cumulative mechanical damage to the passivation layers. Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation and offer a practical route to improving manufacturing reliability for copper-plated HJT cells.
Copper metallization momentum
The work comes amid growing interest in copper metallization as an alternative to silver contacts in HJT solar cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating. The approach addressed adhesion, contact resistance and stability challenges at the ITO interface.
Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT solar cell. The silver-free device showed a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. The results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
The study was published in Solar Energy as “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells.”
