SinceVision has launched the SGI-N030W, a wide-spot laser displacement sensor intended for high-speed, non-contact, micrometre-level dimensional measurement on rough, textured and irregular surfaces. The sensor extends the company’s SGI Series and uses an expanded laser spot with optical triangulation to address measurement instability that conventional point-spot laser systems can encounter when surface finishes vary.
According to SinceVision, point-spot sensors concentrate reflected laser energy on a small area, so microscopic scratches, grain boundaries, brushed textures and matte finishes can produce signal variations that are interpreted as dimensional changes. Those variations can lead to false defect warnings and additional inspection. The SGI-N030W collects reflected light across a broader area and averages localised microscopic peaks and valleys before signal conversion, reducing the influence of surface roughness and optical scattering. The company identifies drawn metals, sandblasted surfaces and coated battery foils as relevant materials.
Measurement specifications and interfaces
The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm when measuring a diffuse white target under static conditions, and linearity of ±0.02% of full scale across the range. A sampling frequency of 50 kHz, equivalent to a 20 µs update interval, is intended to support high-speed measurement and monitoring of dynamic processes.
Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage signals. Master-slave synchronisation allows two sensors to operate in opposition, measuring simultaneously from either side of a component or moving material.
Battery electrode thickness measurement
One principal application cited by SinceVision is in-line thickness measurement of lithium-ion battery electrodes. Coating thickness and uniformity affect energy density, internal resistance and long-term cell stability. Conventional offline inspection with contact micrometers or drop indicators can introduce operator variability and may deform wet or uncured electrode materials, while periodic spot measurements cannot provide continuous coverage across a production reel, according to the company.
The proposed arrangement uses two synchronised sensors above and below a moving electrode web. Mounted on a calibrated, low-thermal-expansion marble gantry, the opposing heads measure their respective clearances to the material; a system controller combines those readings with the fixed mounting datum to calculate absolute electrode thickness in real time. SinceVision says production trials demonstrated stable, repeatable thickness measurement within ±0.3 µm at a web speed of 300 mm/s. The 50 kHz sampling rate is intended to provide longitudinal resolution for detecting localised coating agglomerations, edge thinning and exposed substrate areas before the electrode proceeds to cell winding.
Semiconductor and precision assembly uses
SinceVision also intends the sensor for semiconductor manufacturing, where non-contact measurement is important for sensitive wafer surfaces. Potential uses include wafer position verification, edge detection, height measurement, and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems.
In precision assembly, the sensor can monitor dynamic movement of voice coil motors, linear actuators and micro-steppers. Its sampling rate is intended to capture transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot across the full measurement range. Position data can be sent to machine control systems through the Ethernet interface for real-time monitoring and process control.
Surface-related error challenge
Jack Li, Global Sales and Marketing Director at SinceVision, says false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He explains that conventional point-beam laser sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing production lines and creating a need for additional manual inspection. The SGI-N030W’s expanded optical spot is designed to average out surface-related variations, while synchronisation between opposing sensor heads supports high-speed thickness verification, according to Li.
